Views: 77 Author: Site Editor Publish Time: 2023-02-20 Origin: Site
First of all: in the process of use, we must strictly operate in accordance with the operating procedures in the instruction manual, let alone overload the machine and use it, and before complaining about the production, that is, the operation of the machine, we must check all aspects of the machine. Whether the parts can work normally, and whether there is any failure, only when all the parts and indicators of the machine are normal can it be started and put into production, otherwise it will cause loss to the machine.
Second: After checking the various parts of the high-frequency welded pipe unit, we will start the operation again. During the production process of the machine, we must ensure that the temperature of the machine and the stability of the production situation are stable. If the machine fails, it must be removed in time. Stop production to check what parts of the machine have problems, so as not to cause greater losses. The main faults include unstable mechanical operation, grinding of the machine, and whether there is any abnormal noise during operation. If there is a problem, it should be checked in time.
Third: After the machine has been used for a period of time, we must pay attention to the regular lubrication and cleaning of the machine to ensure that the machine is clean. Only in this way can the machine run normally, and it is relatively light during use. The aging parts must be replaced in time to ensure that the machine can operate normally at any time. In addition, the high-frequency welded pipe unit should be kept well when the machine is not applicable, and it cannot be discarded arbitrarily.
Square cold-formed hollow section steel is a section steel with square cross-section shape and size made of hot-rolled steel plate after cold-bending and then high-frequency welding. It is also called welded square steel pipe. The section steel has a stable production process and high precision, and
The straight seam welded pipe unit sends the strip steel into the welded pipe unit, and after rolling by multiple rollers, the strip steel is gradually rolled up to form a round tube billet with an opening gap. Adjust the reduction of the extrusion roller to control the weld seam gap at 1~3mm, and m
First of all: in the process of use, we must strictly operate in accordance with the operating procedures in the instruction manual, let alone overload the machine and use it, and before complaining about the production, that is, the operation of the machine, we must check all aspects of the machine