Views: 280 Author: Site Editor Publish Time: 2022-10-09 Origin: Site
Our requirements for heat saws:
Low noise, isolation and absorption.
The front and rear guide sleeves improve the quality of the nozzle and remove the tail. The bottom of the saw cover is slope-shaped, and the slope is larger. Add a water blowing mechanism to clean the iron filings at the bottom of the saw cover. Timed blowing, the blowing duration is adjustable.
Add idler rollers at the front and rear to avoid wear of the guide sleeve.
Clamping can be canceled to improve synchronous tracking ability. (Cancellation is not recommended). Double pump, clamp independent pump.
The pulling structure, the anti-holding wheel can be canceled, which is equivalent to reducing the car body and reducing the wear of the guide rail.
The cylinder base is strengthened to prevent any vibration and damage. The critical part that bears the sawing force.
The position of the oil cylinder can be adjusted to adapt to the wear of the saw blade. The adjustment amount is generally 50mm.
The small wheels are installed on the outside of the car body and are easy to disassemble.
When the wheel is worn, the height of the wheel axle can be adjusted. Avoid the three-legged phenomenon when the wheels are worn. 3mm.
Add a keyway and a cross key between the saw arm support and the saw box body. (After passing the factory acceptance, it will be welded before leaving the factory). Here is the non-fragile part.
The 5V belt is used for the motor belt, and the transmission torque is 3-5 times that of the B-type belt and 2-3 times that of the C-type belt. The pulley has a protective cover.
The linear speed of the saw blade ensures that the steel pipe has no large internal and external burrs, and the intermediate linear speed is selected according to the actual range, wall thickness range, and outer diameter range. (The user provides the outer diameter, wall thickness and material of the steel pipe. 195-355B).
The DC solenoid valve coil is added with a freewheeling
Square cold-formed hollow section steel is a section steel with square cross-section shape and size made of hot-rolled steel plate after cold-bending and then high-frequency welding. It is also called welded square steel pipe. The section steel has a stable production process and high precision, and
The straight seam welded pipe unit sends the strip steel into the welded pipe unit, and after rolling by multiple rollers, the strip steel is gradually rolled up to form a round tube billet with an opening gap. Adjust the reduction of the extrusion roller to control the weld seam gap at 1~3mm, and m
First of all: in the process of use, we must strictly operate in accordance with the operating procedures in the instruction manual, let alone overload the machine and use it, and before complaining about the production, that is, the operation of the machine, we must check all aspects of the machine